How To Completely Lift A Car On All Four Jack Stands

25 Nov 2016 03:01 565
132,134
3,957 103

How To Completely Lift Your Car Off The Ground (All Four Wheels)
2-Ton Jack (Low Profile) - http://amzn.to/2fv0zOK
Subscribe for new videos every Wednesday! - https://goo.gl/VZstk7

Tools Used:
2-Ton Jack (Low Profile) - http://amzn.to/2fv0zOK
Jack Stands (2 Ton) - http://amzn.to/2fS7qmi
Wheel Chocks - http://amzn.to/2g7GEFQ

Related Videos:
Honda S2000 Playlist - https://goo.gl/FflSr1

1. To start, make sure the car is on level ground.

2. Apply the parking brake, and place wheel chocks to ensure the car doesn’t roll. Block the rear wheels when lifting the front, and block the front wheels when lifting the rear.

3. Next you’ll need to locate the jacking points; some cars will have one at the front and one in the back. If they don’t, nearly all cars will have jacking points behind each of the front wheels, and in front of each of the rear wheels. You can refer to your owners manual to locate the jacking points.

4. First we’re going to lift the front of the car onto jack stands. If you have a front jacking point, use this, if not you can use the rear jacking points, and slide a jack stand under each side of the front of the car once it’s high enough. This will require jacking both sides of the car, to get both front jack stands underneath. Place jack stands underneath each of the jacking points on the sides up front, and lower the car down onto the jack stands. Remember, you may not want to jack the car to the full desired height; I will be starting at the lowest jack setting because I still need to be able to access the rear jacking point, and I also don’t want to have the jack stands tip over.

5. Now bring the floor jack to the rear of the car, and lift it via the rear jacking point. In this case we’re lifting by the rear differential; often times you can find a tow hook, which can also serve as a jacking point. It’s a good idea to throw a shop rag on top of the jack to ensure that you don’t scratch up the differential casing.

6. Lift up the rear of the car, place the jack stands underneath, and lower the car down onto them. Ideally you want all of the jack stands at the same height, so that the car is level.

7. If you need to raise the vehicle further, do so by incrementally lifting the front and rear to your desired lift height. You simply want to be careful to ensure that the car doesn’t cause the jack stands to tip over.

8. Once you’ve got the car level and all the jack stands adjusted appropriately, give the car a bit of a shake to make sure it’s safe to get underneath. Since I’m paranoid and also enjoy living, I like to place wood blocks underneath each of the wheels as an extra precaution.

9. Now this obviously isn’t necessary if you plan on removing the wheels, and in that case you typically will want to slightly loosen the lug nuts before lifting the vehicle, unless you have an impact wrench available to use.

Engineering Explained is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.

Don't forget to check out my other pages below!
Facebook: http://www.facebook.com/engineeringexplained
Official Website: http://www.howdoesacarwork.com
Twitter: http://www.twitter.com/jasonfenske13
Instagram: http://www.instagram.com/engineeringexplained
Car Throttle: https://www.carthrottle.com/user/engineeringexplained
EE Extra: https://www.youtube.com/channel/UCsrY4q8xGPJQbQ8HPQZn6iA

NEW VIDEO EVERY WEDNESDAY!

Related of "How To Completely Lift A Car On All Four Jack Stands" Videos